Awning Installation Guide

Installing your awning is simple with the right tools and careful planning. Follow these step-by-step instructions to ensure proper assembly and installation.

Tools Needed

• Impact driver drill
• Measuring tape
• Level (3' recommended)
• ½" hex head impact driver
• T-30 impact bit
• Painter's tape (recommended for marking)

Step 1: Inspect and Unpack

Remove all parts from the shipping box and inspect them for any damages. A detailed list of parts and fasteners is included in the box.

For each awning:

• (2) Legs with tabs
• (1) Main roof frame
• (1) Top roof sheet

Step 2: Assemble the Frame

• Fasten the legs to the main roof frame using the existing pilot holes on the underside of the frame.
• Use the provided hex head self-tapping screws to secure the legs.

Step 3: Position and Attach the Frame

1. Lift the awning frame into place and center it on the wall.
2. Secure the frame to the wall using the triangular wall tabs on the back of the roof frame.
3. Use the provided lag screws and ensure they hit studs for a strong hold.
4. Use a level to make sure the frame is straight before screwing it in.

Tips:

• Mark the desired location on the wall with painter’s tape before lifting the frame into position.
• This helps save time and ensures proper leveling and centering.
• (2–3 people are recommended for this step.)

Step 4: Secure the Legs

Fasten the legs squarely to the wall using the provided lag screws. This locks the frame securely into place.

Step 5: Attach the Top Sheet

1. Lift the top roof sheet onto the awning frame.
2. Secure it to the frame using the hex head self-tapping screws.

Step 6: Final Check

• Use the level to ensure the awning is secured and visually aligned.
• If adjustments are needed, repeat from Step 3 to achieve the correct positioning.