Double Door (Drywalled or Trimmed Finish Openings) Installation Guide

(For Drywalled or Trimmed Finish Openings)

Installing your Steel and Stone Double Doors is straightforward with the right tools and this step-by-step guide. Follow these instructions carefully for a seamless installation.

Tools Needed

• Level
• Impact drill with T-25 bit
• Phillips bit
• Multi-tool with wood-cutting blade

Step 1: Inspect the Components

Unbox all pieces and inspect them for any damages or broken glass. Address any concerns with our office before proceeding.

Step 2: Address Baseboards (if applicable)

• If baseboards are present, mark and remove a 3.125” wide section where the door will be installed.
• Alternatively, remove the baseboards entirely and reattach them after installation.

Step 3: Position the Frame

• Place the frame in the opening, ensuring the hinges face the desired door swing direction.
• Use a level to check that the frame is plumb in the opening.

Step 4: Secure the Frame

Using the provided lag screws and shims, secure the frame to the studs through the ½” pre-drilled holes to level the frame.

Step 5: Prepare the Hinges

• Slide brass spacers onto the male ends of the hinges.
• Apply the provided lubricant for smooth hinge operation.

Step 6: Attach the Doors

Seat the doors onto the hinges. (This step requires two people for safety and precision.) Close the doors and adjust the frame as necessary to ensure it is plumb and aligned.

Step 7: Install Hole Plugs

Place the provided black hole plugs over the ½” holes and pop them into place.

Step 8: Install the Magnets

• Attach the magnets to the top inside corners of the doors.
• Test the closure to ensure the magnets contact the frame and keep the doors securely closed.

Step 9: Attach the Center Strap

Position the center strap halfway on the front of the left-side door and secure it with the provided self-tapping screws.

Step 10: Enjoy Your New Steel and Stone Doors!

Step back and admire your newly installed doors.